Gyrotactic microorganisms bioconvection in combined convective magnetohydrodynamic Casson nanofluid flow over a vertically surfaced saturated porous media with variable viscosity

The current article focuses on mass and thermal transfer analysis of a two-dimensional immovable combined convective nanofluid flow including motile microorganisms with temperature-dependent viscosity on top of a vertical plate through a porous medium, and a model has been developed to visualize the velocity slip impacts on a nonlinear partial symbiotic flow. The governed equations include all of the above physical conditions, and suitable nondimensional transfigurations are utilized to transfer the governed conservative equations to a nonlinear system of differential equations and obtain numerical solutions by using the Shooting method. Numerical studies have been focusing on the effects of intricate dimensionless parameters, namely, the Casson fluid parameter, Brownian motion parameter, thermophoresis parameter, Peclet number, bioconvection parameter, and Rayleigh number, which have all been studied on various profiles such as momentum, thermal, concentration, and density of microorganisms. The concentration boundary layer thickness and density of microorganisms increased as the Casson fluid parameter, Brownian and thermophoresis parameters increased, whereas the bioconvection parameter, Peclet number, and Rayleigh number increased. The thermal boundary layer thickness, concentration boundary layer thickness, and density of microorganisms all decreased. The velocity distribution decreases as the Peclet number, bioconvection, and thermophoresis parameters rise but rises as the Rayleigh number, Brownian motion parameter, and Casson fluid parameter rise. These are graphed via plots along with divergent fluid parameters.     

Mathematical modeling of growth of Salmonella spp. and spoilage microorganisms in raw oysters

The main objective of this study was to develop the primary and secondary models to describe the growth kinetics of Salmonella as well as background microorganisms in raw, shucked oysters. Samples, inoculated with a cocktail of two Salmonella serotypes, S. Typhimurium (CICC22956) and S. Enteritidis (CICC21482), were incubated at 4, 8, 12, 16, 20, 25, 30, 33, 37, 40, and 43 °C. Growth of Salmonella was observed at all temperatures, except at 4 °C. The background microorganisms grew at all temperatures. All growth curves clearly exhibited lag, exponential and stationary phases, and were analyzed using the Huang growth model. Three secondary models (Ratkowsky square-root, Huang square-root, and Cardinal parameter models) were compared for evaluating the effect of temperature on bacterial growth rates. Data analysis was performed using IPMP 2013, a free predictive microbiology software tool developed by the USDA ARS.The Cardinal parameters model underestimated the specific rates of the microorganisms at low temperatures. The Huang square-root model was more suitable than the Ratkowsky square-root model for describing the effect of temperature on growth of Salmonella, while the Ratkowsky square-root model, on the other hand, was more suitable for background microorganisms. For both Salmonella and background microorganisms, the logarithms of the lag phase were expressed as linear functions of the logarithms of specific growth rates. The results of this study can be used by the food retailers and regulatory agencies to estimate the microbial shelf-life of raw, shucked oysters.     

磁絮凝强化技术处理厌氧消化污泥脱水液

为满足后续生物处理单元对固体悬浮物（SS）和铁浓度的进水要求，采用磁絮凝强化技术对厌氧消化污泥脱水液进行预处理。通过正交试验和单因素试验，本文考察了混凝水力条件、聚合氯化铝（PAC）投加量、聚丙烯酰胺（PAM）投加量、磁粉投加量及药剂投加顺序对磁絮凝效果的影响。试验结果表明：磁絮凝强化技术在快搅300r/min（2min）、慢搅100r/min（15min）、静置10min时，依次投加磁粉（40mg/L）、PAC（30mg/L）、PAM（4mg/L）时处理效果最好。在此运行条件下，SS和Fe³⁺去除率分别为97.61%、98.24%、絮凝指数（FI值）取得最大值、zeta电位绝对值最小，絮凝效果最佳。与对照相比，磁絮凝强化技术对SS和Fe³⁺去除率分别可提高3.70%和10.82%，同时絮体最大沉降速度可提高33%。磁絮凝技术处理后的出水不仅可以满足后续生物处理单元对SS和铁浓度的要求，还可以有效提高磁絮凝体的沉降速度，减小沉淀时间，具有较好的实用价值。     

GY-340厌氧胶的技术发展回顾

本文是关于GY-340厌氧胶及其相关产品的一些研制情况回顾和评论，并介绍了用组合引发剂的厌氧胶可以获得较好的固化和贮存性能。     

生物除铬(VI)效果及机理探讨

以特定污泥挂膜的自制厌氧生物滤床系统具有良好的去铬(VI)能力。恒流泵最佳流量为47mL/min,外加碳源使废水COD约140mg/L,铬(VI)的浓度由60mg/L左右降到0.5mg/L以下(一级排放标准),需要4h,而对照组(未加碳源)需要14h。铬(VI)浓度由64.66mg/L提高到75.53mg/L时,对系统负面影响甚微,提高到95.47mg/L时,系统出水达标所需时间延长到7.5h。添加微量金属离子与未添加微量金属离子的情况相比,处理效率提高21.26%。分析试验表明:铬(VI)的去除途径可能是由生物还原作用将六价铬还原为三价铬,形成氢氧化铬沉积于微生物表面。     

TNT-RDX混合废水处理的实验研究——生物-吸附法

介绍了在２５￣３５℃的温度下，用厌氧－兼氧－水生生物－吸附组合工艺处理ＴＮＴ和ＲＤＸ混合废水的方法，进行了日处理量为６０￣９００Ｌ的实验室放大实验。当ＴＮＴ和ＲＤＸ混合废水总浓度为４￣１２ｍｇ／Ｌ时，经过该工艺处理后可达到国家排放标准。其中厌氧－兼氧能去除废水中８０％以上的ＴＮＴ和ＲＤＸ，水生生物（水葫芦）对ＴＮＴ及ＲＤＸ也有一定的降解效果，最后用活性炭吸附可以实现深度处理。     

油田采出水的高温水解-好氧处理工艺研究

根据油田采出水的水质特征，采用厌氧(水解)-好氧(接触氧化)处理工艺。实验表明，虽然油田采出水的BOD5／CODCr，较低，属于难生物降解废水，但是当温度为50～60℃时，选择厌氧停留时间为6h，好氧停留时间为3．5h，气水比为10～20，可使其出水的CODCr稳定在120mg／L左右。如果排除Cl^-产生的影响，CODCr，约为60～70mg／L，达到GB8978-1996一级排放标准。     

Municipal solid waste conversion to energy

In recent years it has been recognised by an increasing number of nations that there is considerable energy potential within MSW. As a result many countries have established R,D& D programmes to examine methods of exploiting this potential. The IEA's MSW Conversion Activity was set up in 1986 to provide an infrastructure for sharing information and co-ordinating work in this area internationally. This Activity was extended in 1989 and currently a total of 9 nations participate in it.

To cope with the wide scope of the area (encompassing both biological and thermal processing of MSW) the Activity was divided into three subgroups or Expert Working Groups (EWGs). Each of these dealt with a distinct area of expertise:

1. •Downstream effects of source separation and screening of MSW

2. •Sampling and analytical protocols

3. •Landfill gas

In addition to these groups a central secretariat based at Harwell (UK) has provided guidance, established and administered databases of contacts and produced a series of national reports.

This paper describes the achievements of the Activity and discusses work proposed for the future.     

The bioconversion of tunisian phosphorite usingAspergillus niger

It is well known that the production of phosphoric fertilizers by traditional methods is connected with certain environmental problems, particularly related to use of acids during the decomposition of natural phosphates. A basic problem is also the fact that only 15 – 20% of the phosphorus contained in superphosphates is assimilated by plants.The development of methods to process natural phosphates without acid precipitation has potential advantages and in this respect biotechnological processing of natural phosphates in order to obtain organo-mineral fertilizers is very promising. The possibility of bioconverting the phosphorus of natural phosphates by usingAspergillus niger fungi through their deep incubation has been investigated. The investigations aim to achieve a high degree of P₂O₅ extraction from the phosphates with conversion from a non-utilizable to a utilizable form. The influence of the fungal strain, the kind of nutritive medium and the time of incubation of the process of biological mobilization of the phosphate rock is examined.It was established that the time of incubation, the kind of micro-organisms of theAspergillus niger group, as well as the kind of nutritive medium, influence significantly the process of bioconversion and the conversion of phosphorus from non-utilizable to water-soluble and utilizable for plants form. A maximum degree 90% of phosphorus extraction in the form of water-soluble and citrate-soluble has been reached for 10-day incubation. Physicochemical examinations have been carried out and they have proved that, as a result of the produced organic acids, a process of decomposition of the initial Tunisian phosphorite takes place.